Equus 3130 - Scan Tool – OBD2 Manual do Utilizador descarregar pdf (Página 10)

About the Scan Tool

ADJUSTMENTS AND SETTINGS

8 OBD2

■ The selected character displays “solid”, and the next character

begins flashing.

3. Select the remaining characters in the DTC in the same way, press-

ing the DTC SCROLL button to confirm each character.When

you have selected all the DTC characters, press the ENTER/LD

button to view the DTC definiition.

■ If you entered a “Generic” DTC

(DTCs that start with “P0”, “P2” and

some “P3”):

- The selected DTC and DTC defi-

nition (if available) show on the

Scan Tool’s display.

■ If you entered a “Manufacturer-

Specific” DTC (DTCs that start with

“P1” and some “P3”):

- The “Select Manufacturer” screen

displays.

- Use the UP and DOWN

buttons, as necessary, to high-

light the appropriate manufactur-

er, then press the ENTER/LD

button to display the correct

DTC for your vehicle.

If a definition for the DTC you

entered is not available, an advi-

sory message shows on the Scan

Tool’s display.

4. If you wish to view definitions for additional DTCs, press the

ENTER/LD button to return to the Enter DTC screen, and

repeat steps 2 and 3.

5. When all desired DTCs have been viewed, press the ERASE

button to exit the DTC Library.

Adjusting Display Brightness

1. Use the UP and DOWN but-

tons, as necessary, to highlight Adjust

Brightness in the MENU, then press

the ENTER/LD button.

■ The Adjust Brightness screen dis-

plays.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Sem comentários

Equus 3130 - Scan Tool – OBD2 Manual do Utilizador Página 10