Equus 3130 - Scan Tool – OBD2 Manual do Utilizador descarregar pdf (Página 48)

Additional Tests

NON-CONTINUOUS TEST

46 OBD2

NON-CONTINUOUS TEST

The Non-Continuous Test function retrieves and displays test results

for emission-related powertrain components and systems that are not

continuously monitored. The tests available are determined by the

vehicle manufacturer.

The Scan Tool does not perform non-continuous test, but

retrieves results from the most recently performed tests from

the on-board computer’s memory. You may retrieve non-con-

tinuous test results for only one test at any given time.

1. From the "Mode Selection Menu", use

the UP and DOWN buttons, as

necessary, to highlight Non-Continuous

Test, then press the ENTER/LD

button.

■ The “Select Test” screen displays.

The screen shows all tests applicable

to the vehicle under test. Refer to the

vehicle’s service repair manual for infor-

mation related to non-continuous tests.

If non-continuous tests are not

supported by the vehicle under

test, an advisory message shows

on the Scan Tool's display. Press

the ENTER/LD button to

return to the Mode Selection menu.

2. Use the UP and DOWN but-

tons, as necessary, to highlight the

desired test, then press the ENTER/LD

button.

3. A “One moment please. . .” message diplays while the request is

sent to the vehicle’s on-board computer.

4. When test results have been retrieved, data for the selected test will

show on the Scan Tool’s display. The display shows the following

information:

■ Test ID number

■ Module ID number

■ Component ID number

■ Min or Max test limit

Only one test limit, either Min or Max, is shown for any

given test.

■ Test Value and status

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 59 60

Comentários a estes Manuais

Sem comentários

Equus 3130 - Scan Tool – OBD2 Manual do Utilizador Página 48

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Equus 3130 - Scan Tool – OBD2